Global Finishing Solutions

14' W x 14' H x 54' L Large Equipment Crossdraft Non-Pressurized Booth

Item #
Request For Quote
The simplest, most cost-effective configuration, air flows horizontally through a crossdraft booth, parallel to the floor and over the product. Crossdraft airflow starts at the front of the booth, with air entering the booth through either filtered products doors (non-pressurized booths) or an intake chamber (pressurized booths). Air exits the booth through an exhaust plenum located at the rear of the booth.

Request For Quote

Booth Features:

GFS Large Equipment Booths are constructed from single-skin, 18-gauge, G90 galvanized sheet steel and use structural steel columns and beams. Horizontal booth panels are assembled onto the booth’s frame from the ground up for added structural integrity, simplified installation and fewer height restrictions. Solid nut-and-bolt construction and pre-punched panels ensure consistent alignment and placement.

Designed and manufactured by GFS for optimal brightness, Large Equipment Booths feature integrated four-tube, insideaccess light fixtures. Light fixtures are ETL and ETL-C listed, and come complete with T8 ballasts and LED lamps.

High-powered fans and motors supply optimal airflow throughout the paint booth, creating a cleaner environment for a better paint job. Each Large Equipment Paint Booth includes a non-sparking, tube axial exhaust fan(s) with belt guards and duct connector ring, along with a UL/CUL and CSA recognized three-phase, TEFC, tri-voltage motor.

Pre-engineered Large Equipment models and options are fully ETL and ETL-C listed, ensuring that the entire booth complies with applicable safety codes and meets performance requirements. ETL listing facilitates successful inspections and demonstrates that Large Equipment Booths have completed independent, third-party review.

Swing-type product doors (either filtered or solid, depending on airflow and pressurization) and at least one personnel door come standard with each pre engineered Large Equipment Booth. Doors feature heavy-duty hinges with plate steel and replaceable brass brushings. Hinges guarantee long-lasting performance with no sagging.

A UL/CUL listed electromechanical or Velocity® control panel is available with each Large Equipment Paint Booth, although highly customized booths may require a custom control panel. Electromechanical control panels are suited for non-pressurized booths, and are used to operate booth exhaust, safety interlocks and lights. The Velocity control panel offers additional features, including an Allen-Bradley touch screen interface, management of spray, cure and flash modes and auto-balancing on pressurized booths.

To ensure the safety of painters and equipment, a manometer and air solenoid valve are included with all Large Equipment Booths to maintain an optimal working environment inside the booth. Manometers monitor overspray buildup on exhaust filters, while air solenoid valves prevent spraying in the booth when fans are off or light covers are open. Limit switches come standard on pressurized booths to safely shut down spray guns when the booth doors are open.

GFS Enclosed Finishing Paint Booths come complete with a full set of high efficiency, 20-by-20-inch GFS Wave exhaust and tacky intake filters. Installing and replacing filters is easy with the grid system; you can avoid waste and save cost by replacing only the filter squares that need changing. An included manometer indicates when filters need to be replaced.

Important Documents

More Information
Manufacturer Global Finishing Solutions
Pressurized / Non-Pressurized Non-Pressurized
Width 14'
Height 14'
Length 54'
Airflow Style Crossdraft
Exhaust Fan Quantity 1
Exhaust Fan Size 40''
Exhaust Fan Horsepower 7.5 HP
CFM 19600
Static Pressure 3/4"
Front Opening Filtered swing door
Back Opening Solid-wall
Search engine powered by ElasticSuite